The width of the steel drag chain can be customized according to user requirements, and the bending radius is between 800-50. When cables and pipes need to be disassembled and repaired frequently, or when the pipe joint specification is larger than the inner cavity of the support plate.

    General support plates can be used and split steel-aluminum drag chains can be used. When larger cables and pipes are required to bear the load, high-strength support plates and monolithic steel-aluminum drag chains should be used. The pins should be made of alloy steel or Manganese steel is carburized, which can enhance the wear resistance and hardness, and then increase the service life and strength of the steel-aluminum drag chain.

The support plate should be made of extruded aluminum alloy with standard thickness. When there are many standard types of cables and pipes, general support plates and frame-type steel-aluminum drag chains can be used. The support plates of the drag chains must be carburized, and the steel plate must be To use national standard steel plate, some manufacturers use non-standard steel plate, the drag chain piece is too large (the thickness is not good). In this way, the strength of the drag chain is significantly reduced, and the service life cannot be guaranteed, and it will collapse if it is slightly extended.

     The height of the chain plate, which is also the height of the support plate, is determined by the maximum diameter of the cable. When the machine tool works at the maximum limit, if the width of the drag chain exceeds 300mm, and the length of the drag chain exceeds 4m, it should be considered for stability reasons. Select towing chains with a larger specification.